Home › Power Source / Network › 8NR-FTS (BATTERY / CHARGING) › CHARGING SYSTEM › 2016.10–2021.09
RM32H0E _57 Power Source / Network _060209 8NR-FTS BATTERY / CHARGING _0295688 CHARGING SYSTEM C

8NR-FTS BATTERY / CHARGING  CHARGING SYSTEM  P16027B  Deterioration of Battery Low Fluid Level  


DESCRIPTION

The ECM determines the battery status according to the voltage of the BATT terminal while the engine is running (not cranking).

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P16027B Deterioration of Battery Low Fluid Level Battery capacity is low for 10 seconds or more when the engine is running (not cranking).
(1 trip detection logic)
·

Battery

·

Wire harness or connector


Charge warning light does not come on DTC stored
·

SAE Code: P1602

·

w/ Battery Current Sensor



WIRING DIAGRAM

A395873E01
0.531,0.927 2.365,1.125 1.833,0.198 10 false from Battery 5.323,0.813 5.938,1.01 0.615,0.198 10 false BATT 5.344,2.323 5.656,2.521 0.313,0.198 10 false E1 4.938,0.948 5.396,1.146 0.458,0.198 10 false A38 5.021,0.698 5.177,0.896 0.156,0.198 10 false 1 4.938,2.333 5.396,2.531 0.458,0.198 10 false C62 5,2.115 5.313,2.313 0.313,0.198 10 false 53 5.885,2.979 6.344,3.177 0.458,0.198 10 false ECM 2.615,1.094 4.76,1.292 2.146,0.198 10 false EFI-MAIN NO. 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


HINT:

If any DTCs other than P16027B are output, troubleshoot those DTCs first.


PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.

Disconnect the ECM connector.


b.
A354486C15
0.167,0.667 0.667,0.917 0.5,0.25 0.667,1.417 1.198,1.104 true 0.198,0.177 0.51,0.375 0.313,0.198 10 false *a 0.281,1.323 0.708,1.552 0.427,0.229 10 false BATT 0.292,0.698 0.906,0.896 0.615,0.198 10 false A38
*a Front view of wire harness connector
(to ECM)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A38-1 (BATT) - Body ground Always 11 to 14 V



Result:
Result
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR