Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio and Display Type)
RM32H0E _56 Audio / Visual / Telematics _060227 AUDIO / VIDEO _0295690 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  B1585  USB Device Malfunction  


DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1585 USB Device Malfunction USB Device Malfunction
·

Non mass-storage class or incompatible protocol USB device

·

USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT)

·

"iPod" malfunction

·

"iPod" with unsupported firmware

·

Unsupported "iPod" model


·

USB device or "iPod"

·

Radio and display receiver assembly



DTC Detection Conditions.
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3 Pattern 4 Pattern 5
Diagnosis Condition - - - - - -
Malfunction Status A non mass-storage class or incompatible protocol USB device is connected ○ - - - -
USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) is connected - ○ - - -
"iPod" malfunction - - ○ - -
"iPod" with unsupported firmware is connected - - - ○ -
Unsupported "iPod" model is connected - - - - ○
Detection Time - - - - -
Number of Trips 1 trip 1 trip 1 trip 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Turn the ignition switch off.

HINT:

When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.



c.

Turn the ignition switch to ACC.


d.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>SYSTEM DESCRIPTION




Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio and Display Type)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE

NG