Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for LED Headlight) › 2016.10–2019.09
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0295714 HEADLIGHT ASSEMBLY(for LED Headlight) A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY(for LED Headlight)  REPAIR  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

·

Ensure that the headlight assembly is not damaged.



PROCEDURE

Hide 81193C 1.INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

a.
E351129

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E351130

Install the upper headlight protector retainer with the screw.


Hide 81193B 2.INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

a.
E395005

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.
E395006C01
0.656,1.229 0.385,0.938 true 0.188,0.802 0.375,0.99 0.188,0.188 10 false *a
*a Cut Line


Cut off the part of the upper No. 2 headlight protector retainer as shown in the illustration.


c.
E395007

Install the upper No. 2 headlight protector retainer with the 2 screws.


Hide 81193E 3.INSTALL UPPER NO. 3 HEADLIGHT PROTECTOR RETAINER

a.
E393865

Cut off the part shaded in the illustration and sand smooth with sandpaper.

HINT:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.



b.

for Type A :

i.
E351134

Install the upper No. 3 headlight protector retainer with the 2 screws.



c.

for Type B :

i.
E395002C01
0.479,1.052 0.823,0.896 true 0.281,0.979 0.469,1.167 0.188,0.188 10 false *a
*a Cut Line


Cut off the part of the upper No. 3 headlight protector retainer as shown in the illustration.


ii.
E395001

Install the upper No. 3 headlight protector retainer with the 3 screws.