Home › Vehicle Exterior › WINDOW / GLASS › WINDOW DEFOGGER SYSTEM
RM32H0E _59 Vehicle Exterior _060314 WINDOW / GLASS _0295741 WINDOW DEFOGGER SYSTEM U

WINDOW / GLASS  WINDOW DEFOGGER SYSTEM  TERMINALS OF ECU  


CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for TMMT MADE)


a.

Disconnect the F72 air conditioning amplifier assembly connector.

E358496E01
2.406,0.146 2.823,0.406 0.417,0.26 2.49,0.198 2.948,0.396 0.458,0.198 10 false F72


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
F72-5 (IG+) - F72-29 (GND) B - W-B Power source (IG) Ignition switch ON 11 to 14 V
F72-5 (IG+) - F72-29 (GND) B - W-B Power source (IG) Ignition switch off Below 1 V
F72-1 (B) - F72-29 (GND) V - W-B Battery power supply Always 11 to 14 V
F72-29 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the F72 air conditioning amplifier assembly connector.


d.

Measure the voltage and check for pulses according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
F72-26 (RDFG) - F72-29 (GND) P - W-B Rear window defogger signal Ignition switch ON, rear window defogger switch off 11 to 14 V
F72-26 (RDFG) - F72-29 (GND) P - W-B Rear window defogger signal Ignition switch ON, rear window defogger switch on Below 1 V
F72-3 (LIN1) - F72-29 (GND) L - W-B*1
BE - W-B*2
LIN communication line Ignition switch ON Pulse generation

If the result is not as specified, the air conditioning amplifier assembly may be malfunctioning.

*1: for LHD

*2: for RHD




CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for TMC MADE)


a.

Disconnect the F73 air conditioning amplifier assembly connector.

B429611E02
2.229,0.385 2.604,0.625 0.375,0.24 3.844,0.406 4.229,0.635 0.385,0.229 2.302,0.427 2.76,0.625 0.458,0.198 10 false F71 3.917,0.427 4.375,0.625 0.458,0.198 10 false F73


b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Tester Connection Wiring Color Terminal Description Condition Specified Condition
F73-2 (IG+) - F73-4 (GND) B - W-B Power source (IG) Ignition switch ON 11 to 14 V
F73-2 (IG+) - F73-4 (GND) B - W-B Power source (IG) Ignition switch off Below 1 V
F73-1 (B) - F73-4 (GND) V - W-B Battery power supply Always 11 to 14 V
F73-4 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the F73 air conditioning amplifier assembly connector.


d.

Measure the voltage and check for pulses according to the value(s) in the table below.

Tester Connection Wiring Color Terminal Description Condition Specified Condition
F73-5 (RDFG) - F73-4 (GND) P - W-B Rear window defogger signal Ignition switch ON, rear window defogger switch off 11 to 14 V
F73-5 (RDFG) - F73-4 (GND) P - W-B Rear window defogger signal Ignition switch ON, rear window defogger switch on Below 1 V
F73-14 (LIN1) - F73-4 (GND) BE - W-B LIN communication line Ignition switch ON Pulse generation

If the result is not as specified, the air conditioning amplifier assembly may be malfunctioning.



CHECK AIR CONDITIONING CONTROL ASSEMBLY


a.

Check for pulses according to the value(s) in the table below.

E358495E04
3.302,0.188 3.698,0.448 0.396,0.26 3.385,0.229 3.844,0.427 0.458,0.198 10 false F61

Tester Connection Wiring Color Terminal Description Condition Specified Condition
F61-2 (LIN1) - F61-16 (GND) L - W-B*1
BE - W-B*2
LIN communication line Ignition switch ON Pulse generation

*1: for TMMT Made

*2: for TMC Made


If the result is not as specified, the air conditioning control assembly may be malfunctioning.