Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH › 2016.10–2019.09
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0296122 HEADLIGHT DIMMER SWITCH A

LIGHTING (EXT)  HEADLIGHT DIMMER SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the headlight dimmer switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)
Removal/installation of the spiral cable with sensor sub-assembly Steering angle neutral point (Initialize panoramic view monitor system)
·

Simple Intelligent Parking Assist System

·

Toyota parking assist-sensor system (w/Simple Intelligent Parking Assist System)


(Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 84307 1.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 84650 2.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

Hide 84140 3.REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

a.
E351163C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the connector.


b.

Disengage the claws to remove the headlight dimmer switch assembly as shown in the illustration.