Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › 2016.10–2019.09
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0296123 STOP LIGHT SWITCH G

LIGHTING (EXT)  STOP LIGHT SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 84340 1.INSPECT STOP LIGHT SWITCH ASSEMBLY

a.
E361512C01
1.438,0.25 1.948,0.5 0.51,0.25 1.313,1.198 0.917,1.75 true 1.958,1.198 1.646,1.719 true 2.26,1.198 2.5,1.74 true 0.177,0.146 0.49,0.302 0.313,0.156 10 false *a 1.583,0.292 1.896,0.448 0.313,0.156 10 false A45 0.75,1.76 1.167,1.958 0.417,0.198 10 false GND 1.604,1.75 1.917,1.906 0.313,0.156 10 false B 2.479,1.75 2.792,1.906 0.313,0.156 10 false B
*a Front view of wire harness connector
(to Stop Light Switch Assembly)


Disconnect the A45 stop light switch assembly connector.


b.

Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A45-7 (B) - A45-2 (GND) Ignition switch off 11 to 14 V
A45-6 (B) - A45-2 (GND) Ignition switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
A45-2 (GND) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the wire harness or connector.


c.
E233300C62
1.469,0.271 1.823,0.521 0.354,0.25 1.927,1.115 2.406,1.677 true 2.073,1.063 2.531,0.76 true 1.813,1.115 1.99,1.677 true 1.688,1.115 1.167,1.677 true 1.26,0.594 1.542,1.063 true 0.188,0.115 0.417,0.281 0.229,0.167 10 false *a 1.531,0.313 1.979,0.573 0.448,0.26 10 false A45 2.583,0.677 3.031,0.896 0.448,0.219 10 false OUT 2,1.708 2.313,1.917 0.313,0.208 10 false L 2.302,1.698 2.802,1.917 0.5,0.219 10 false GND 1,1.698 1.448,1.958 0.448,0.26 10 false ACC 1.167,0.49 1.479,0.698 0.313,0.208 10 false L
*a Component with harness connected
(Stop Light Switch Assembly)


Reconnect the A45 stop light switch assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A45- 1 (OUT) - A45-2 (GND) Ignition switch off, brake pedal not depressed Below 1 V
A45-1 (OUT) - A45-2 (GND) Ignition switch off, brake pedal depressed 11 to 14 V
A45-3 (L) - A45-2 (GND) Ignition switch off, brake pedal not depressed Below 1 V
A45-3 (L) - A45-2 (GND) Ignition switch off, brake pedal depressed 11 to 14 V
A45-4 (ACC) - A45-2 (GND) Ignition switch off 11 to 14 V
A45-5 (L) - A45-2 (GND) Ignition switch on (IG), brake pedal not depressed 11 to 14 V
A45-5 (L) - A45-2 (GND) Ignition switch on (IG), brake pedal depressed Below 1 V


If the result is not as specified, replace the stop light switch assembly.