Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM32H0E _59 Vehicle Exterior _060313 LIGHTING (EXT) _0296124 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the height control sensor sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear height control sensor sub-assembly LH Initialize headlight ECU sub-assembly LH Automatic headlight beam level control system (Click here)

PROCEDURE

Hide 1.REMOVE REAR WHEEL (for LH Side)

Hide 89408C 2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
E351176C01
0.844,1.135 0.469,0.99 true 2.844,2.833 2.688,2.5 true 0.208,0.875 0.417,1.083 0.208,0.208 10 true *a 2.906,2.771 3.104,2.979 0.198,0.208 10 true *b
*a Clamp
*b Fook


Disconnect the connector.


b.

Disengage the clamp.


c.

Remove the 2 bolts.


d.

Disengage the hook to remove the rear height control sensor sub-assembly LH.

NOTICE:

If the rear height control sensor sub-assembly LH has been struck or dropped, replace it with a new one.