Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0297206 BLIND SPOT MONITOR SYSTEM W

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE BLIND SPOT MONITOR SYSTEM


a.

Customizing with the GTS

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the blind spot monitor system on.


iv.

Turn the GTS on.


v.

Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / Warning.


vi.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
BSM Buzzer Volume Adjust Sets the volume of the RCTA buzzer (blind spot monitor buzzer). Medium 001:Low,011:Medium,101:High Blind Spot Monitor Sensor LH (Master)
BSM Mirror Indicator Brightness Sets the brightness of the indicators in the outer rear view mirror assemblies. Bright 001:Dark,101:Bright Blind Spot Monitor Sensor LH (Master)
RCTA Function Switches the RCTA function on and off. ON 0:ON,1:OFF Blind Spot Monitor Sensor RH (Slave)
50006 7