Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for 8NR-FTS)
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0297888 CRUISE CONTROL SYSTEM(for 8NR-FTS) C

CRUISE CONTROL  CRUISE CONTROL SYSTEM(for 8NR-FTS)  U012287  Lost Communication with Vehicle Dynamics Control Module Missing Message  


DESCRIPTION

The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
U012287 Lost Communication with Vehicle Dynamics Control Module Missing Message While the vehicle speed is 40 km/h (25 mph) or more and the cruise control main switch (ON/OFF button) is on, signals cannot be received from the skid control ECU (brake actuator assembly) for 2.65 seconds or more.
·

CAN communication system

·

ECM

·

Skid control ECU (brake actuator assembly)



CAUTION / NOTICE / HINT

HINT:

Refer to troubleshooting in CAN Communication System.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 8NR-FTS)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 374

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

1.

Drive the vehicle at a speed for which cruise control operation is possible.

2.

Turn the cruise control system on using the cruise control main switch (ON/OFF button).

3.

Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 8NR-FTS)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 374

Result:
Result Proceed to
DTC U012287 is not output A
DTC U012287 is output B



A

B