Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for 8NR-FTS)
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0297888 CRUISE CONTROL SYSTEM(for 8NR-FTS) C

CRUISE CONTROL  CRUISE CONTROL SYSTEM(for 8NR-FTS)  P160700  Cruise Control Input Processor  


DESCRIPTION

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store the DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
P160700 Cruise Control Input Processor When prohibited by the sub-CPU, the cruise control system operates for 0.3 seconds or more. ECM

CAUTION / NOTICE / HINT

HINT:

The ECM receives signals from each sensor to control all functions of the cruise control system. When a malfunction is detected, the fail-safe function operates until the ignition switch off.


PROCEDURE

1.CHECK FOR DTCs (CRUISE CONTROL SYSTEM)
a.

Clear the DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 8NR-FTS)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Clear DTCs
50002 374

b.

Perform the following to make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the malfunction cannot be detected.

1.

Turn the cruise control system on using the cruise control main switch (ON/OFF button).




c.

Check for DTCs.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for 8NR-FTS)>DTC CHECK / CLEAR

Powertrain > Cruise Control > Trouble Codes
50001 374

Result:
Result Proceed to
DTC P160700 is not output A
DTC P160700 is output B



A

B