The millimeter wave radar sensor assembly communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | w/o Full-speed range following function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the ECM and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. w/ Full-speed range following function:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the ECM and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. |
·
CAN communication system ·
ECM ·
Millimeter wave radar sensor assembly |
| U0125 | Lost Communication with Yaw Rate Sensor Module | w/o Full-speed range following function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the yaw rate sensor and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. w/ Full-speed range following function:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the yaw rate sensor and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. |
·
CAN communication system ·
Yaw rate sensor (airbag sensor assembly) ·
Millimeter wave radar sensor assembly |
| U0126 | Lost Communication with Steering Angle Sensor Module | w/o Full-speed range following function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the steering sensor and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. w/ Full-speed range following function:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the steering sensor and the millimeter wave radar sensor assembly is detected for approximately 1 second or more. |
·
CAN communication system ·
Steering sensor ·
Millimeter wave radar sensor assembly |
| U0129 | Lost Communication with Brake System Control Module | w/o Full-speed range following function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake actuator assembly) and the millimeter wave radar sensor assembly is detected for approximately 2.5 seconds or more. w/ Full-speed range following function:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake actuator assembly) and the millimeter wave radar sensor assembly is detected for approximately 2.5 seconds or more. |
·
CAN communication system ·
Skid control ECU (brake actuator assembly) ·
Millimeter wave radar sensor assembly |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF button).
w/ Full-speed range following function: Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.
w/o Full-speed range following function: Drive the vehicle at 36 km/h (22 mph) or more for 5 seconds or more.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0100, U0125, U0126 and U0129 are not output | A |
| DTC U0100, U0125, U0126 or U0129 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING