The ECM communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN communication system DTCs are stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication With ECM/PCM "A" Missing Message | w/o Full-speed range following function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, the ECM continuously receives a communication cut-off signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more. w/ Full-speed range following function:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, the ECM continuously receives a communication cut-off signal from the skid control ECU (brake actuator assembly) for approximately 1 second or more. |
·
CAN communication system ·
ECM ·
Skid control ECU (brake actuator assembly) |
| U012287 | Lost Communication with Vehicle Dynamics Control Module Missing Message | When the ignition switch to ON and the dynamic radar cruise control system is operating, a communication error between the skid control ECU (brake actuator assembly) and the ECM is detected for approximately 2.6 seconds or more. | ·
CAN communication system ·
ECM ·
Skid control ECU (brake actuator assembly) |
| U110487 | Lost Communication with Cruise Control Module Missing Message | w/o Full-speed range following function:
·
While the vehicle speed is 36 km/h (22 mph) or more and the dynamic radar cruise control system is operating, a communication error between the millimeter wave radar sensor assembly and ECM is detected for 1 second or more. w/ Full-speed range following function:
·
While the vehicle speed is 5 km/h (3 mph) or more and the dynamic radar cruise control system is operating, a communication error between the millimeter wave radar sensor assembly and ECM is detected for 1 second or more. |
·
CAN communication system ·
ECM ·
Millimeter wave radar sensor assembly |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Turn the ignition switch to ON.
Turn the dynamic radar cruise control system on using the cruise control main switch (ON/OFF button).
w/ Full-speed range following function: Drive the vehicle at 5 km/h (3 mph) or more for 5 seconds or more.
w/o Full-speed range following function: Drive the vehicle at 36 km/h (22 mph) or more for 5 seconds or more.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>DYNAMIC RADAR CRUISE CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U010087, U012287 and U110487 are not output | A |
| DTC U010087, U012287 or U110487 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING