Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM (w/ Steering Control) › 2016.10–2020.08
RM32H0E _51 Engine / Hybrid System _059516 CRUISE CONTROL _0297892 LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) U

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM(w/ Steering Control)  TERMINALS OF ECU  


FORWARD RECOGNITION CAMERA


NOTICE:
·

DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

·

Do not apply excessive force to the R5 forward recognition camera connector.



a.

Check forward recognition camera

E256359E73
1.708,0.729 2.146,0.979 0.438,0.25 1.833,0.781 2.292,0.979 0.458,0.198 10 false R5

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
R5-7 (IGB) - Body ground B - Body ground Power source Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V
R5-10 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω
R5-5 (CA1P) - Body ground R - Body ground CAN communication signal Ignition switch ON Pulse generation
(Waveform 1)
R5-11 (CA1N) - Body ground GR - Body ground Pulse generation
(Waveform 2)
R5-6 (CANH) - Body ground G - Body ground Pulse generation
(Waveform 1)
R5-12 (CANL) - Body ground R - Body ground Pulse generation
(Waveform 2)


b.

WAVEFORM 1

i.
A292386E03
1.344,1.917 2.313,2.146 0.969,0.229 10 false 10 μsec./DIV. 2.76,0.219 3.333,0.427 0.573,0.208 10 false 1 V/DIV. 3,1.406 3.365,1.583 0.365,0.177 10 false GND

CAN communication signal

Item Content
Terminal Name Between R5-5 (CA1P) and R5-10 (GND)
Between R5-6 (CANH) and R5-10 (GND)
Tester Range 1 V/DIV., 10 μsec./DIV.
Condition Ignition switch ON

HINT:

The waveform varies depending on the CAN communication signal.




c.

WAVEFORM 2

i.
A292387E07
3,1.375 3.344,1.573 0.344,0.198 10 false GND 2.781,0.26 3.417,0.458 0.635,0.198 10 false 1 V/DIV. 1.375,1.885 2.323,2.135 0.948,0.25 10 false 10 μsec./DIV.

CAN communication signal

Item Content
Terminal Name Between R5-11 (CA1N) and R5-10 (GND)
Between R5-12 (CANL) and R5-10 (GND)
Tester Range 1 V/DIV., 10 μsec./DIV.
Condition Ignition switch ON

HINT:

The waveform varies depending on the CAN communication signal.