The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the stereo component amplifier assembly removal/installation are shown below.
*1: When performing learning using the GTS.
*2: w/ Stop and start system
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY LH
86183D
2.REMOVE AUDIO AMPLIFIER COVER
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull the audio amplifier cover in the direction indicated by the arrow (1) shown in the illustration to disengage the clips.
Pull the audio amplifier cover in the direction indicated by the arrow (2) shown in the illustration to disengage the guide to remove the audio amplifier cover.
86280
3.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET
Disengage the clamp.
Disconnect the connector.
| *a | Lock Lever |
|
Remove in this Direction |
Disengage the claw and pull the lock lever to disconnect the connector as shown in the illustration.
Turn back the part of the front floor carpet assembly.
Remove the 2 bolts and remove the stereo component amplifier assembly with bracket.
86286
4.REMOVE NO. 2 AMPLIFIER BRACKET
Remove the 2 screws and No. 2 amplifier bracket from the stereo component amplifier assembly.
86285
5.REMOVE NO. 1 AMPLIFIER BRACKET
Remove the 2 screws and No. 1 amplifier bracket from the stereo component amplifier assembly.