Home › Audio / Visual / Telematics › AUDIO / VIDEO › PILLAR SPEAKER
RM32H0E _56 Audio / Visual / Telematics _060227 AUDIO / VIDEO _0298062 PILLAR SPEAKER G

AUDIO / VIDEO  PILLAR SPEAKER  INSPECTION  


PROCEDURE

Hide 86160J 1.INSPECT FRONT NO. 3 SPEAKER ASSEMBLY

a.

Check the resistance.

i.
E226097C83
1,2.25 1.313,1.802 true 1.583,2.25 1.667,1.813 true 2.094,2.25 1.948,1.813 true 2.583,2.25 2.302,1.792 true 0.167,0.167 0.479,0.323 0.313,0.156 10 false *a 0.771,2.26 1.479,2.458 0.708,0.198 10 false TWR-*A 1.542,2.26 1.854,2.417 0.313,0.156 10 false - 1.896,2.26 2.521,2.448 0.625,0.188 10 false TWR+*A 2.563,2.26 2.875,2.417 0.313,0.156 10 false + 0.771,2.448 1.479,2.646 0.708,0.198 10 false TWL-*B 1.896,2.448 2.521,2.635 0.625,0.188 10 false TWL+*B
*A for RH
*B for LH
*a Component without harness connected
(Front No. 3 Speaker Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for RH
Tester Connection Condition Specified Condition
2 (TWR+) - 4 (TWR-) Always 10 kΩ or higher
1 (+) - 3 (-) Always 10 kΩ or higher
1 (+) - 2 (TWR+) Always Below 1 Ω
3 (-) - 4 (TWR-) Always Below 1 Ω

for LH
Tester Connection Condition Specified Condition
2 (TWL+) - 4 (TWL-) Always 10 kΩ or higher
1 (+) - 3 (-) Always 10 kΩ or higher
1 (+) - 2 (TWL+) Always Below 1 Ω
3 (-) - 4 (TWL-) Always Below 1 Ω


If the result is not as specified, replace the front No. 3 speaker assembly.