52536
1.INSTALL FRONT BUMPER SIDE RETAINER LH
|
Install in this Direction |
Engage the claw to install the front bumper side retainer LH as shown in the illustration.
| *a | Bolt |
| *b | Screw |
Install the screw.
Install the bolt.
16595B
2.INSTALL NO. 1 RADIATOR AIR GUIDE LH
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and claw to install the No. 1 radiator air guide LH as shown in the illustration.
16593B
3.INSTALL NO. 1 RADIATOR AIR GUIDE RH
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guide and claw to install the No. 1 radiator air guide RH as shown in the illustration.
52535
4.INSTALL FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
52134G
5.INSTALL FRONT BUMPER BRACKET LH
Install the front bumper bracket LH with the 4 bolts.
52133F
6.INSTALL FRONT BUMPER BRACKET RH
Use the same procedure as for the LH side.
52132A
7.INSTALL NO. 2 FRONT BUMPER REINFORCEMENT
Install the No. 2 front bumper reinforcement with the 2 nuts.
57014A
8.INSTALL FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH
Install the front side member bracket sub-assembly LH with the 4 bolts.
57013C
9.INSTALL FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
52131A
10.INSTALL FRONT BUMPER REINFORCEMENT
Install the front bumper reinforcement with the 6 bolts.
Engage the wire harness clamps.
52618
11.INSTALL LOWER FRONT BUMPER ABSORBER
|
Install in this Direction |
Install the lower front bumper absorber as shown in the illustration.
52611
12.INSTALL FRONT BUMPER ENERGY ABSORBER
|
Install in this Direction |
Install the front bumper energy absorber as shown in the illustration.
16561C
13.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL
|
Install in this Direction |
Install the No. 1 radiator to support seal as shown in the illustration.
Engage the wire harness clamp and install the 2 clips.
53117C
14.INSTALL NO. 1 RADIATOR GRILLE RETAINER
|
Install in this Direction |
Engage the claws to install the No. 1 radiator grille retainer as shown in the illustration.
52129B
15.INSTALL FRONT BUMPER LOWER COVER
Engage the claws and guides to install the front bumper lower cover.
| *a | Outside Moulding Retainer |
| *b | Clip |
| *c | Grommet |
Install the 2 clips and 8 outside moulding retainers.
Install the 8 grommets.
53114C
16.INSTALL INNER RADIATOR GRILLE
|
Install in this Direction |
Engage the claws to install the inner radiator grille as shown in the illustration.
52114A
17.INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET
for Extension Mounting Bracket Type A:
|
Install in this Direction |
Engage the claws to install the front bumper extension mounting bracket as shown in the illustration.
Install the 2 screws.
for Extension Mounting Bracket Type B:
|
Install in this Direction |
Engage the claws to install the front bumper extension mounting bracket as shown in the illustration.
Install the 2 screws.
52128B
18.INSTALL FRONT BUMPER HOLE COVER
Engage the hook to install the front bumper hole cover.
Engage the claws.
53879H
19.INSTALL FRONT FENDER LINER RETAINER
Engage the claws to install the front fender liner retainer.
Use the same procedure for the opposite side.
52146B
20.INSTALL FRONT BUMPER SIDE MOUNTING BRACKET LH
|
Install in this Direction |
Engage the claws to install the front bumper side mounting bracket LH as shown in the illustration.
Install the screw and clip.
52145C
21.INSTALL FRONT BUMPER SIDE MOUNTING BRACKET RH
Use the same procedure as for the LH side.
81482C
22.INSTALL FOG LIGHT COVER LH (w/o Fog Light)
Install the fog light cover LH with the 3 screws.
81481E
23.INSTALL FOG LIGHT COVER RH (w/o Fog Light)
Use the same procedure as for the LH side.
81482C
24.INSTALL FOG LIGHT COVER LH (w/ Fog Light)
Install the fog light cover LH with the 3 screws.
81481E
25.INSTALL FOG LIGHT COVER RH (w/ Fog Light)
Use the same procedure as for the LH side.
81220
26.INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)
Engage the guide to install the fog light assembly LH.
Install the 2 screws.
81210A
27.INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure as for the LH side.
52128C
28.INSTALL FRONT BUMPER EXTENSION LH
Engage the claws and guide to install the front bumper extension LH.
52127D
29.INSTALL FRONT BUMPER EXTENSION RH
Use the same procedure as for the LH side.
85271
30.INSTALL WASHER HOSE (w/ Headlight Cleaner System)
Engage the clamps to install the washer hose.
85208A
31.INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)
85207A
32.INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
85354
33.INSTALL HEADLIGHT WASHER COVER LH (w/ Headlight Cleaner System)
85353
34.INSTALL HEADLIGHT WASHER COVER RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
82119C
35.INSTALL NO. 5 ENGINE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)
w/ Simple Intelligent Parking Assist System:
Engage the clamps to install the No. 5 engine room wire.
w/o Simple Intelligent Parking Assist System:
Engage the clamps to install the No. 5 engine room wire.
89347D
36.INSTALL FRONT CENTER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
89347C
37.INSTALL FRONT CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
89341L
38.INSTALL FRONT SIDE ULTRASONIC SENSOR RETAINER (w/ Simple Intelligent Parking Assist System)
89347B
39.INSTALL FRONT CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89341K
40.INSTALL FRONT CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89341M
41.INSTALL FRONT SIDE ULTRASONIC SENSOR (w/ Simple Intelligent Parking Assist System)
53111
42.INSTALL RADIATOR GRILLE