Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › 2016.10–2019.09
RM32H0E _59 Vehicle Exterior _060783 EXTERIOR PANELS / TRIM _0298065 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.


PROCEDURE

Hide 52592 1.REMOVE REAR BUMPER SIDE SEAL LH

a.
B453498

Remove the 6 clips and rear bumper side seal LH.


Hide 52591 2.REMOVE REAR BUMPER SIDE SEAL RH

HINT:

Use the same procedure as for the LH side.


Hide 75652 3.SEPARATE QUARTER OUTSIDE MOULDING LH

a.
B458899

Remove the 2 screws.


b.
B461478C01
0,0 0,0 false
V100155

Protective Tape
V100135

Push
V113146

Place Hand Here
V113147

Remove in this Direction


Apply protective tape around the quarter outside moulding LH.


c.

Disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.

NOTICE:

To avoid damaging the claws, do not forcibly pull the quarter outside moulding LH.



d.

Disengage the clip to disconnect the quarter outside moulding LH from the rear bumper assembly.


Hide 75651 4.SEPARATE QUARTER OUTSIDE MOULDING RH

HINT:

Use the same procedure as for the LH side.


Hide 5.REMOVE REAR BUMPER ASSEMBLY

a.
B453501

Remove the 4 clips.


b.
B453502C01
1.969,1.104 2.25,0.854 true 2.333,0.719 2.552,0.896 0.219,0.177 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the claws to open the rear bumper upper cover LH.

HINT:

Use the same procedure for the RH side and LH side.



c.
B453503

Remove the bolt.

HINT:

Use the same procedure for the RH side and LH side.



d.
B453504C01
0,0 0,0 false
V100155

Protective Tape
V113147

Remove in this Direction


Apply protective tape around the rear bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.



e.

Disengage the claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B453505C01
1.552,0.26 1.781,0.458 0.229,0.198 12 true *A
*A w/ Wire Harness
V113147

Remove in this Direction


Disengage the claws as shown in the illustration.


g.

w/ Wire Harness:

i.

Disconnect the connector.



h.

Remove the rear bumper assembly.