Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › 2016.10–2019.09
RM32H0E _59 Vehicle Exterior _060783 EXTERIOR PANELS / TRIM _0298065 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  DISASSEMBLY  


PROCEDURE

Hide 89342B 1.REMOVE REAR SIDE ULTRASONIC SENSOR (w/ Simple Intelligent Parking Assist System)

Hide 89342 2.REMOVE REAR CORNER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89342A 3.REMOVE REAR CENTER ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89348T 4.REMOVE REAR SIDE ULTRASONIC SENSOR RETAINER (w/ Simple Intelligent Parking Assist System)

Hide 89348R 5.REMOVE REAR CORNER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 89348S 6.REMOVE REAR CENTER ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 82169A 7.REMOVE NO. 6 FLOOR WIRE (w/ Wire Harness)

a.

w/ Simple Intelligent Parking Assist System and Rear Fog Light:

i.

Disengage the clamps to remove the No. 6 floor wire.

B458619


ii.

Disconnect the connector.



b.

w/ Rear Fog Light:

i.

Disengage the clamps to remove the No. 6 floor wire.

B458620


ii.

Disconnect the connector.



c.

w/ TOYOTA Parking Assist-sensor System:

i.

Disengage the clamps to remove the No. 6 floor wire.

B458902



Hide 81480B 8.REMOVE REAR FOG LIGHT ASSEMBLY (w/ Rear Fog Light)

a.
B458622

Remove the 2 screws and rear fog light.


Hide 81481Q 9.REMOVE FOG LIGHT BRACKET (w/o Rear Fog Light)

a.
B458623

Remove the 2 screws and fog light bracket.


Hide 52166A 10.REMOVE REAR BUMPER UPPER COVER LH

a.
B458624

Disengage the hook to remove the rear bumper upper cover LH.


Hide 52165A 11.REMOVE REAR BUMPER UPPER COVER RH

HINT:

Use the same procedure as for the LH side.


Hide 81920 12.REMOVE REFLEX REFLECTOR ASSEMBLY LH

a.
B461479C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the screw.


b.

Disengage the claw and guide to remove the reflex reflector assembly LH as shown in the illustration.


Hide 81910 13.REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 52164A 14.REMOVE REAR BUMPER PLATE LH

a.
B458626C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the 2 screws.


b.

Disengage the claws to remove the rear bumper plate LH as shown in the illustration.


Hide 52163A 15.REMOVE REAR BUMPER PLATE RH

HINT:

Use the same procedure as for the LH side.


Hide 52756 16.REMOVE REAR BUMPER MOULDING RETAINER LH (w/ Rear Bumper Moulding Retainer)

a.
B458647C01
1.635,1.271 1.844,1.448 0.208,0.177 10 true *1
*1 Outside Moulding Retainer


Remove the 2 nuts.


b.

Remove the outside moulding retainer.


c.

Remove the No. 2 rear bumper side retainer LH and rear bumper moulding retainer LH with No. 1 rear spoiler protector.


d.
B458648

Remove the No. 1 rear spoiler protector from the rear bumper moulding retainer LH.


Hide 52755 17.REMOVE REAR BUMPER MOULDING RETAINER RH (w/ Rear Bumper Moulding Retainer)

HINT:

Use the same procedure as for the LH side.


Hide 52162B 18.REMOVE NO. 1 REAR BUMPER PLATE

a.
B458627

Disengage the claws.


b.
B458628

Disengage the hook to remove the No. 1 rear bumper plate.


Hide 52461F 19.REMOVE REAR BUMPER PAD

a.
B458629

Remove the rear bumper pad.


Hide 52463 20.REMOVE REAR BUMPER PAD LH

a.
B458903

Remove the rear bumper pad LH.


Hide 52462 21.REMOVE REAR BUMPER PAD RH

HINT:

Use the same procedure as for the LH side.


Hide 52154B 22.REMOVE REAR BUMPER SIDE STAY LH

a.
B458630C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the clip and screw.


b.

Disengage the claw to remove the rear bumper side stay LH as shown in the illustration.


Hide 52153A 23.REMOVE REAR BUMPER SIDE STAY RH

HINT:

Use the same procedure as for the LH side.


Hide 52453 24.REMOVE REAR BUMPER CENTER GUARD

a.

Remove the 2 clips and 6 outside moulding retainers.

B458631C01
1.458,0.927 1.667,1.125 0.208,0.198 10 true *b 1.042,1.396 1.292,1.563 0.25,0.167 10 true *b 0.531,1.542 0.74,1.719 0.208,0.177 10 true *b 0.479,2.156 0.698,2.365 0.219,0.208 10 true *a 5.552,0.979 5.76,1.177 0.208,0.198 10 true *b 6.021,1.385 6.229,1.583 0.208,0.198 10 true *b 6.51,1.552 6.719,1.75 0.208,0.198 10 true *b 6.615,2.063 6.833,2.271 0.219,0.208 10 true *a
*a Clip *b Outside Moulding Retainer



b.

Disengage the claws and guides to remove the rear bumper center guard.

B458632


Hide 52576B 25.REMOVE REAR BUMPER SIDE RETAINER LH

a.
B458633C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Remove the 2 screws.


b.

Disengage the claw and guide to remove the rear bumper side retainer LH as shown in the illustration.


Hide 52575 26.REMOVE REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 52563A 27.REMOVE REAR BUMPER UPPER RETAINER LH

a.
B458634C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the claws and rear combination light cover LH as shown in the illustration.


b.
B458635C01
0.656,1.021 1.073,0.604 true 1.49,0.823 1.906,0.406 true 1.76,1.104 2.344,0.521 true 2.417,0.427 2.583,0.594 0.167,0.167 10 true *a 1.979,0.302 2.146,0.469 0.167,0.167 10 true *b 0.458,0.917 0.625,1.083 0.167,0.167 10 true *a
*a Guide
*b Pin
V113147

Remove in this Direction


Remove the 3 screws.


c.

Disengage the pin and guide as shown in the illustration.


d.
B458909

Disconnect the connector to remove the rear combination light assembly LH.


e.
B458636C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guides to remove the rear bumper upper retainer LH as shown in the illustration.


Hide 52562B 28.REMOVE REAR BUMPER UPPER RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 52023 29.REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY (for Type A)

a.
B458637

Remove the 8 bolts and rear bumper reinforcement sub-assembly.


Hide 52015A 30.REMOVE REAR BUMPER ARM SUB-ASSEMBLY RH (for Type B)

a.
B458913

Remove the 4 bolts and rear bumper arm sub-assembly RH.