76872
1.INSTALL NO. 1 REAR SPOILER PROTECTOR
Using the same procedure, install every No. 1 rear spoiler protector.
When installing the No. 1 rear spoiler protector, heat the rear spoiler using a heat light.
| Item | Temperature |
|---|---|
| Rear Spoiler | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear spoiler excessively.
Clean the rear spoiler surface.
Using a heat light, heat the rear spoiler surface.
Remove the double-sided tape from the rear spoiler.
Wipe off any tape adhesive residue with cleaner.
Using a heat light, heat the rear spoiler.
Remove the release paper from a new No. 1 rear spoiler protector.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Line |
Install the No. 1 rear spoiler protector as shown in the illustration.
Install the No. 1 rear spoiler protector along the line on the rear spoiler.
81935D
2.INSTALL CENTER STOP LIGHT CORD ASSEMBLY
Engage the guides to install the center stop light cord assembly.
76087A
3.INSTALL REAR SIDE SPOILER SUB-ASSEMBLY
Engage the guide to install the No. 5 rear spoiler retainer.
Install the screw.
|
Install in this Direction |
Engage the guide and claws to install the rear side spoiler sub-assembly as shown in the illustration.
81570
4.INSTALL CENTER STOP LIGHT ASSEMBLY
76873
5.INSTALL NO. 2 REAR SPOILER PROTECTOR
Using the same procedure, install every No. 2 rear spoiler protector.
When installing the No. 2 rear spoiler protector, heat the rear spoiler using a heat light.
| Item | Temperature |
|---|---|
| Rear Spoiler | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear spoiler excessively.
Clean the rear spoiler surface.
Using a heat light, heat the rear spoiler surface.
Remove the double-sided tape from the rear spoiler.
Wipe off any tape adhesive residue with cleaner.
Using a heat light, heat the rear spoiler.
Remove the release paper from new No. 2 rear spoiler protector.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Line |
Install the No. 2 rear spoiler protector as shown in the illustration.
Install each No. 2 rear spoiler protector along the line on the rear spoiler.
76892
6.INSTALL NO. 2 REAR SPOILER
|
Install in this Direction |
Engage the claws to install the No. 2 rear spoiler as shown in the illustration.
Install the 2 screws.