Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR OUTSIDE MOULDING › 2016.10–2020.08
RM32H0E _59 Vehicle Exterior _060783 EXTERIOR PANELS / TRIM _0298082 REAR DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR OUTSIDE MOULDING  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 75393 1.INSTALL NO. 2 OUTSIDE MOULDING RETAINER (for TMMT Made)

a.

When using a new rear door outside moulding:

i.

Clean the surface of a new rear door outside moulding.



b.

When reusing the rear door outside moulding:

i.

Remove the double-sided tape from the rear door outside moulding.


ii.

Wipe off any tape adhesive residue with cleaner.



c.

Install a new No.2 outside moulding retainer.

i.

Remove the peeling paper from the face of the No.2 outside moulding retainer.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.
B458740C01
0.469,1.052 0.99,1.052 0.99,1.052 0.542,1.146 true 2.833,1.063 2.479,1.063 2.479,1.063 2.896,1.125 true 1.063,0.917 1.281,1.104 0.219,0.188 10 true *1 0.583,0.76 0.75,0.927 0.167,0.167 10 true *a 2.208,0.927 2.427,1.115 0.219,0.188 10 true *1 2.635,0.76 2.802,0.927 0.167,0.167 10 true *a
*1 Mark-off Line
*a 4.0 mm (0.157 in.)


Install the No.2 outside moulding retainer as shown in the illustration.



Hide 75797 2.INSTALL REAR DOOR UPPER OUTSIDE MOULDING PAD

a.

When using a new rear door outside moulding:

i.

Clean the surface of a new rear door outside moulding.



b.

When reusing the rear door outside moulding:

i.

Remove the double-sided tape from the rear door outside moulding.


ii.

Wipe off any tape adhesive residue with cleaner.



c.

Install a new rear door upper outside moulding pad.

i.

Remove the peeling paper from the face of the rear door upper outside moulding pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.
B458741C01
0.823,0.479 1.208,0.667 1.208,0.667 0.938,0.396 true 2.281,0.479 2.208,0.792 2.208,0.792 2.531,0.469 true 0.729,0.156 1.042,0.313 0.313,0.156 10 false *a 2.323,0.146 2.635,0.302 0.313,0.156 10 false *b 1.229,0.688 1.427,0.865 0.198,0.177 10 true *1 2.115,0.813 2.313,0.99 0.198,0.177 10 true *1
*1 Mark-off Line
*a 3.0 mm (0.118 in.)
*b 13 mm (0.512 in.)


Install the rear door upper outside moulding pad as shown in the illustration.