Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › WHEEL OPENING MOULDING (for Front)
RM32H0E _59 Vehicle Exterior _060783 EXTERIOR PANELS / TRIM _0298083 WHEEL OPENING MOULDING(for Front) A

EXTERIOR PANELS / TRIM  WHEEL OPENING MOULDING(for Front)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 75602A 1.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY

a.
B461466C01
0,0 0,0 false
V113147

Install in this Direction


Install the pin hold clip as shown in the illustration.

NOTICE:

Insert the pin hold clip with the slot aligned vertically.

Do not rotate the clip after inserting it.

After installation, confirm that the slot is aligned vertically.


HINT:

Use the same procedure for the RH side and LH side.



b.
B458752C01
0,0 0,0 false
V113147

Install in this Direction


Engage the clips and claws to install the front fender moulding sub-assembly as shown in the illustration.


c.

Install the 3 clips and 5 screws.


d.

Remove the protective tape.