Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75652
1.REMOVE QUARTER OUTSIDE MOULDING
When removing the quarter outside moulding, if the No. 1 body outside moulding pad (double-sided tape) is difficult to remove, heat the adhesive of the quarter outside moulding using a heat light.
| Item | Temperature |
|---|---|
| Quarter Outside Moulding | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the quarter outside moulding excessively.
Remove the 3 screws and clip.
|
Protective Tape |
Apply protective tape around the quarter outside moulding.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.
To avoid damaging the claws, do not forcibly pull the quarter outside moulding.
Disengage the clips and separate the double-sided tape to remove the quarter outside moulding.
| *1 | No. 1 Body Outside Moulding pad (Double-sided Tape) | - | - |
|
Place Hand Here |
|
Remove in this Direction |