Home › Vehicle Exterior › WIPER / WASHER › FRONT WIPER MOTOR
RM32H0E _59 Vehicle Exterior _060316 WIPER / WASHER _0298086 FRONT WIPER MOTOR G

WIPER / WASHER  FRONT WIPER MOTOR  INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Ensure that fingers or articles of clothing do not get caught in moving parts when performing this test.


HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 85110 1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for LHD)

a.
E257561C19
1.396,0.854 0.896,0.313 true 2.333,1.75 1.885,1.229 true 1.083,1.75 1.573,1.229 true 0.115,0.135 0.427,0.333 0.313,0.198 10 false *a 0.656,0.208 0.969,0.406 0.313,0.198 10 false +2 0.99,1.781 1.302,1.979 0.313,0.198 10 false +1 2.323,1.802 2.635,2 0.313,0.198 10 false E
*a Component without harness connected
(Windshield Wiper Motor Assembly)


Check the LO operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 5 (+1)
Battery negative (-) → Terminal 4 (E)
Motor operates at low speed




b.

Check the HI operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 3 (+2)
Battery negative (-) → Terminal 4 (E)
Motor operates at high speed


If the result is not as specified, replace the windshield wiper motor assembly.



Hide 85110 2.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (for RHD)

a.
E257561C20
2.042,0.854 2.396,0.396 true 2.333,1.75 1.885,1.229 true 1.083,1.75 1.573,1.229 true 0.115,0.135 0.427,0.333 0.313,0.198 10 false *a 2.323,1.771 2.635,1.969 0.313,0.198 10 false +2 2.396,0.24 2.708,0.438 0.313,0.198 10 false +1 1,1.792 1.313,1.99 0.313,0.198 10 false E
*a Component without harness connected
(Windshield Wiper Motor Assembly)


Check the LO operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 1 (+1)
Battery negative (-) → Terminal 5 (E)
Motor operates at low speed




b.

Check the HI operation.

i.

Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 4 (+2)
Battery negative (-) → Terminal 5 (E)
Motor operates at high speed


If the result is not as specified, replace the windshield wiper motor assembly.