Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM32H0E _59 Vehicle Exterior _060316 WIPER / WASHER _0298089 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 53851D 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

a.
E356913

Remove the 5 screws and front wheel opening extension pad RH.


Hide 75601A 3.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY RH

Hide 75851 4.REMOVE ROCKER PANEL MOULDING RH

Hide 53875A 5.REMOVE FRONT FENDER LINER RH

a.
E356914

Using a screwdriver, turn the pin 90 degrees counterclockwise and remove the pin hold clips.


b.

Remove the 6 screws, 6 clips and front fender liner RH.

E356915


Hide 6.DRAIN WASHER FLUID

a.
E356916

Disconnect the rear washer hose from the windshield washer motor and pump assembly, and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.



Hide 85310 7.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
E356917C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect the washer hose.


b.

Disconnect the connector.


c.

Remove the windshield washer motor and pump assembly as shown in the illustration.