Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM32H0E _59 Vehicle Exterior _060316 WIPER / WASHER _0298101 RAIN SENSOR G

WIPER / WASHER  RAIN SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89941 1.INSPECT RAIN SENSOR

a.
E267170C29
1.438,0.333 1.833,0.573 0.396,0.24 1.563,1.385 1.115,1.75 true 1.969,1.375 2.417,1.729 true 0.094,0.104 0.344,0.292 0.25,0.188 10 false *a 1,1.771 1.323,1.979 0.323,0.208 10 false ES 2.302,1.771 2.594,1.958 0.292,0.188 10 false SIG 1.552,0.365 1.844,0.552 0.292,0.188 10 false R1
*a Front view of wire harness connector
(to Rain Sensor)


Disconnect the R1 rain sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
R1-4 (SIG) - R1-2 (ES) Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R1-2 (ES) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the harness or connector.


d.
E358632C01
1,1.5 1.563,1 true 2.354,1.51 1.771,0.979 true 0.125,0.104 0.406,0.365 0.281,0.26 10 false *a 0.854,1.542 1.25,1.75 0.396,0.208 10 false MPX 2.271,1.552 2.583,1.75 0.313,0.198 10 false ES
*a Component with harness connected
(Rain Sensor)


Reconnect the R1 rain sensor connector.


e.

Connect an oscilloscope to the rain sensor connector.


f.

Check for pulses.

OK:
Tester Connection Condition Specified Condition
3 (MPX) - 2 (ES) Ignition switch ON Pulse generation


If the result is not as specified, replace the rain sensor.