Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MAIN SWITCH
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298107 PARKING ASSIST MAIN SWITCH G

PARK ASSIST / MONITORING  PARKING ASSIST MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84490D 1.INSPECT IPA MAIN SWITCH ASSEMBLY

a.

Check the resistance.

i.
E159999C10
1.188,2.365 1.438,1.885 true 2.198,2.344 1.979,1.875 true 0.135,0.115 0.448,0.313 0.313,0.198 10 false *a 1.115,2.396 1.469,2.667 0.354,0.271 10 false IG 2.188,2.385 2.542,2.656 0.354,0.271 10 false E
*a Component without harness connected
(IPA Main Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (IG) - 3 (E) IPA main switch assembly pressed Below 1 Ω
6 (IG) - 3 (E) IPA main switch assembly not pressed 10 kΩ or higher


If the result is not as specified, replace the IPA main switch assembly.



b.

Check that the switch illuminates.

i.
E159999C11
1.25,2.333 1.615,1.885 true 2.167,2.333 1.813,1.885 true 0.198,0.177 0.583,0.448 0.385,0.271 10 false *a 1.125,2.365 1.615,2.646 0.49,0.281 10 false ILL+ 2.115,2.365 2.583,2.667 0.469,0.302 10 false ILL-
*a Component without harness connected
(IPA Main Switch Assembly)


Apply battery voltage to the IPA main switch assembly and check that the switch illuminates.

OK:
Connection Specified Condition
Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-)
Illuminates


If the result is not as specified, replace the IPA main switch assembly.