Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL AWD SYSTEM
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0298220 DYNAMIC TORQUE CONTROL AWD SYSTEM U

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  TERMINALS OF ECU  


CHECK 4WD ECU ASSEMBLY


C270073E14
3.333,0.167 3.833,0.417 0.5,0.25 3.458,0.177 3.927,0.344 0.469,0.167 10 false M77

a.

Measure the voltage and resistance of the connector.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
M77-6 (CANH) - M77-5 (CANL) L - W HIGH-level CAN bus wire - LOW-level CAN bus wire Cable disconnected from negative (-) battery terminal 54 to 69 Ω
M77-4 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω
M77-3 (IG1) - M77-4 (GND) V - W-B Power source voltage Ignition switch ON 11 to 14 V
M77-2 (SLC+) - M77-1 (SLC-) W - B 4WD linear solenoid signal D position, Idling Pulse generation (See waveform 1)

If the result is not as specified, the 4WD ECU assembly may have a malfunction.


b.
C170221E01
2.917,1.729 3.271,1.865 0.354,0.135 10 GND

Using an oscilloscope, check the waveform 1.

Waveform 1 (Reference)
Item Content
Terminal No. (Symbol) M77-2 (SLC+) - M77-1 (SLC-)
Tester Range 2 V/DIV., 1 msec./DIV.
Condition D position, Idling