Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL AWD SYSTEM › 2016.10–2019.09
RM32H0E _52 Drivetrain _059725 GF1A TRANSFER / 4WD / AWD _0298220 DYNAMIC TORQUE CONTROL AWD SYSTEM C

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL AWD SYSTEM  C1280/82  Engine Circuit Malfunction  


DESCRIPTION

If a malfunction in the ECM circuit occurs, the 4WD ECU assembly will output this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1280/82 Engine Circuit Malfunction When the following continues for 5 seconds or more:
·

Communication with engine control ECM is operating normally, but engine control system is malfunctioning.


·

Engine control system

·

4WD ECU assembly



CAUTION / NOTICE / HINT

HINT:

Check the condition of each related circuit connector before troubleshooting.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>ELECTRONIC CIRCUIT INSPECTION PROCEDURE


PROCEDURE

1.CHECK FOR DTC (ENGINE CONTROL SYSTEM)
a.

Check if the engine control system DTC is output.

Click hereEngine / Hybrid System>8NR-FTS (ENGINE CONTROL)>SFI SYSTEM>DTC CHECK / CLEAR

Result:
Result Proceed to
Engine control system DTC is not output A
Engine control system DTC is output B




A

B

GO TO ENGINE CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)