Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › INTRUSION SENSOR CANCEL SWITCH
RM32H0E _58 Vehicle Interior _060784 THEFT DETERRENT / KEYLESS ENTRY _0298322 INTRUSION SENSOR CANCEL SWITCH G

THEFT DETERRENT / KEYLESS ENTRY  INTRUSION SENSOR CANCEL SWITCH  INSPECTION  


PROCEDURE

Hide 81260A 1.INSPECT INTRUSION SENSOR CANCEL SWITCH (MAP LIGHT ASSEMBLY)

a.
E358817C02
1.271,1.729 1.458,1.344 true 2.156,1.719 1.813,1.135 true 0.167,0.146 0.479,0.344 0.313,0.198 10 false *a 1.042,1.792 1.49,2 0.448,0.208 10 false SOFF 2.052,1.792 2.5,2 0.448,0.208 10 false GND
*a Component without harness connected
(Intrusion Sensor Cancel Switch (Map Light Assembly))


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
11 (SOFF) - 3 (GND) Intrusion sensor cancel switch is pressed Below 1 Ω
11 (SOFF) - 3 (GND) Intrusion sensor cancel switch is not pressed 10 kΩ or higher


If the resistance is not as specified, replace the intrusion sensor cancel switch (map light assembly).