Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298358 REAR VIEW MONITOR SYSTEM U

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  TERMINALS OF ECU  


RADIO AND DISPLAY RECEIVER ASSEMBLY


E317216E07
5.948,2.417 6.365,2.646 0.417,0.229 3.417,1.385 3.813,1.615 0.396,0.229 5.927,0.177 6.323,0.406 0.396,0.229 3.531,0.115 3.927,0.344 0.396,0.229 1.552,0.146 1.948,0.375 0.396,0.229 0.688,0.146 1.083,0.375 0.396,0.229 3.417,2.51 3.813,2.74 0.396,0.229 0.719,0.188 1.333,0.385 0.615,0.198 10 false F126 1.604,0.167 2.219,0.365 0.615,0.198 10 false F127 3.583,0.146 4.198,0.344 0.615,0.198 10 false F125 5.99,0.219 6.604,0.417 0.615,0.198 10 false F50 3.542,1.406 4.156,1.604 0.615,0.198 10 false j2 6.052,2.448 6.667,2.646 0.615,0.198 10 false RA 3.521,2.552 4.135,2.75 0.615,0.198 10 false BT

a.

Disconnect the F126 and F125 radio and display receiver assembly connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F126-3 (ACC1) - F126-7 (GND1) GR - LA Power source (ACC) Ignition switch off Below 1 V
Ignition switch ACC 11 to 14 V
F126-4 (+B1) - F126-7 (GND1) LA-SB - LA Power source (+B) Ignition switch off 11 to 14 V
F126-7 (GND1) - Body ground LA - Body ground Ground Always Below 1 Ω
F125-1 (IG) - F126-7 (GND1) B - LA Power source (IG) Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V


c.

Reconnect the F126 and F125 radio and display receiver assembly connectors.


d.

Measure the voltage, resistance and waveform according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
F50-11 (CA+) - F50-23 (CGND) B - Shielded Rear television camera assembly power source Ignition switch ACC 5.5 to 7.05 V
F50-12 (V+) - F50-23 (CGND) R - Shielded Video signal Ignition switch ON, shift lever in R, camera lens not covered, displaying an image+ Pulse generation
(See waveform 1)
Ignition switch ON, shift lever in R, camera lens covered, blacking out screen Pulse generation
(See waveform 2)
F50-23 (CGND) - Body ground Shielded - Body ground Shielded ground Always Below 1 Ω
F50-24 (V-) - F50-23 (CGND) W - Shielded Ground Always Below 1 Ω


e.
E265840C03
0.823,2.073 1,2.073 1,2.073 1.125,1.583 false 1.479,2.063 1.344,2.063 1.344,2.063 1.229,1.479 false 0.781,4.167 0.958,4.167 0.958,4.167 1.156,3.594 false 1.521,4.125 1.385,4.125 1.385,4.125 1.271,3.542 false 0.229,0.229 0.542,0.427 0.313,0.198 10 *a 0.396,1.052 0.76,1.313 0.365,0.26 10 GND 0.396,3.208 0.76,3.469 0.365,0.26 10 GND 0.26,2.271 0.625,2.531 0.365,0.26 10 *b 0.646,4.073 1.01,4.333 0.365,0.26 10 *c 0.656,1.979 1.021,2.24 0.365,0.26 10 *c 1.51,1.969 1.875,2.229 0.365,0.26 10 *d 1.542,4.052 1.906,4.313 0.365,0.26 10 *d
*a Waveform 1
*b Waveform 2
*c Synchronization Signal
*d Video Waveform


Reference (Oscilloscope waveform):

i.

Waveform 1

Item Content
Terminal No. (Symbol) F50-12 (V+) - F50-23 (CGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R, camera lens not covered, displaying an image

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.



ii.

Waveform 2

Item Content
Terminal No. (Symbol) F50-12 (V+) - F50-23 (CGND)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R, camera lens covered, blacking out screen

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.