Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Simple Intelligent Parking Assist System) › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060571 PARK ASSIST / MONITORING _0298265 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Simple Intelligent Parking Assist System) C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/ Simple Intelligent Parking Assist System)  C1626  Steering Angle Sensor Failure  


DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a steering angle sensor internal malfunction signal from the spiral cable with sensor sub-assembly via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1626 Steering Angle Sensor Failure A malfunction signal is transmitted from the spiral cable with sensor sub-assembly
·

Spiral cable with sensor sub-assembly

·

Clearance warning ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Calibration.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/ Simple Intelligent Parking Assist System)>CALIBRATION


PROCEDURE

1.REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
a.

Replace the spiral cable with sensor sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
50001 170
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY WAS DEFECTIVE)

NG