84810
1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
| *a | Component without harness connected
(Rear Power Window Regulator Switch Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 (UP) - 7 (GND) | Auto up or up position | Below 100 Ω |
| 4 (DOWN) - 7 (GND) | Auto down or down position | Below 100 Ω |
| 8 (AUTO) - 7 (GND) | Auto up or auto down position | Below 100 Ω |
| 5 (UP) - 7 (GND) | Off | 10 kΩ or higher |
| 4 (DOWN) - 7 (GND) | Off | 10 kΩ or higher |
| 8 (AUTO) - 7 (GND) | Off | 10 kΩ or higher |
If the result is not as specified, replace the rear power window regulator switch assembly.
Check that the LED illuminates.
Apply battery voltage to the power window regulator switch assembly and check that the LED illuminates.
| Battery Connection | Specified Condition |
|---|---|
| Battery positive (+) → 3 (ILL+)
Battery negative (-) → 1 (ILL-) |
LED illuminates |
If the result is not as specified, replace the rear power window regulator switch assembly.