Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE FLUID
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0298576 BRAKE FLUID N

BRAKE SYSTEM (OTHER)  BRAKE FLUID  BLEEDING  


CAUTION / NOTICE / HINT

NOTICE:
·

for Manual Transaxle:

Move the shift lever to neutral and apply the parking brake before bleeding the brakes.

·

for CVT:

Move the shift lever to P and apply the parking brake before bleeding the brakes.

·

Add brake fluid to keep the level between the MIN and MAX lines of the reservoir while bleeding the brakes.

·

If brake fluid leaks onto any painted surface, immediately wash it off.

·

Do not operate the brake actuator assembly while air is in the brake system or in the brake master cylinder sub-assembly. Doing so may cause air to enter the brake actuator assembly.

·

If bleeding the brake actuator assembly is difficult due to air in the brake actuator assembly, replace it with a new one.

·

When bleeding air, select the suitable procedure listed below.

Replaced/Installed Item Work Procedure
Flexible hose (front/rear) Bleed brake line
Disc brake cylinder assembly (front)
Brake actuator assembly
Brake master cylinder sub-assembly
Brake master cylinder reservoir sub-assembly
Brake booster assembly



HINT:

If any work is performed on the brake system or if air in the brake tubes is suspected, bleed the air from the brake system.


PROCEDURE

Hide 1. FILL RESERVOIR WITH BRAKE FLUID

Hide 47201 2.BLEED BRAKE MASTER CYLINDER SUB-ASSEMBLY

NOTICE:
·

To prevent brake fluid from damaging painted surfaces, cover any surrounding parts with a piece of cloth.

·

Be sure to clean your hands before bleeding the master cylinder to avoid any potential contamination of the brake system. Contamination, for example by dirt particles or mineral oil, could lead to functional brake problems.



HINT:

If the brake master cylinder sub-assembly is reinstalled or runs out of brake fluid, bleed the brake master cylinder sub-assembly.


a.
C368468

Using a union nut wrench, disconnect the 2 brake tubes from the brake master cylinder sub-assembly.

NOTICE:
·

Do not damage or deform the brake lines during the removal procedure.

·

Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.




b.
C366036

Slowly depress the brake pedal and hold it.*1


c.
C366037

Cover the 2 outer holes with fingers and release the brake pedal.*2


d.

Repeat steps *1 and *2, 3 or 4 times.


e.
C366038C01
1.823,2.979 2.135,3.135 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using a union nut wrench, connect the 2 brake tubes to the brake master cylinder sub-assembly.

Torque:
Specified tightening torque : 19.5 N*m (199 kgf*cm, 14 ft.*lbf)

NOTICE:
·

Do not kink or damage the brake tubes.

·

Do not allow the brake tubes to twist and interfere with other parts or vehicle body during tightening.

·

Do not allow any foreign matter such as dirt or dust to enter the brake tubes.



HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)): 17.4 N*m (177 kgf*cm, 13 ft.*lbf)




Hide 3.BLEED BRAKE LINE

Hide 4.INSPECT FOR BRAKE FLUID LEAK

Hide 5.INSPECT BRAKE FLUID LEVEL IN RESERVOIR