Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER (for LHD)
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0298577 BRAKE MASTER CYLINDER(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER(for LHD)  REASSEMBLY  


PROCEDURE

Hide 47299 1.INSTALL BRAKE MASTER CYLINDER RESERVOIR STRAINER

a.

Install the brake master cylinder reservoir strainer to the brake master cylinder reservoir assembly.


Hide 47230 2.INSTALL BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY

a.

Install the brake master cylinder reservoir filler cap assembly to the brake master cylinder reservoir assembly.


Hide 47255 3.INSTALL MASTER CYLINDER RESERVOIR GROMMET

a.

Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new master cylinder reservoir grommets.


b.

Install the 2 master cylinder reservoir grommets to the brake master cylinder reservoir assembly.


Hide 47220D 4.INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY

a.

Mount the brake master cylinder body in a vise.

NOTICE:

Place aluminum plates on the vise to prevent damage to the brake master cylinder body.



b.

Install the brake master cylinder reservoir assembly to the brake master cylinder body.

NOTICE:

Do not drop the brake master cylinder reservoir assembly.



c.
C366878

Using an T20 "TORX" socket wrench, install the brake master cylinder reservoir assembly to the brake master cylinder body with the "TORX" screw.

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


d.

Remove the brake master cylinder sub-assembly from the vise.