Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for LHD) › 2016.10–2019.09
RM32H0E _54 Brake _060040 BRAKE SYSTEM (OTHER) _0298586 BRAKE PEDAL(for LHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the brake pedal support assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

CAUTION:
B458500

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 55401E 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 84340 2.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 3.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 47101A 4.REMOVE BRAKE PEDAL RETURN SPRING

a.
C366042

Remove the brake pedal return spring from the brake pedal support assembly and push rod pin.


Hide 47264A 5.REMOVE PUSH ROD PIN

a.
C366043

Remove the clip and push rod pin to separate the brake pedal support assembly from the brake master cylinder push rod clevis.


Hide 47110 6.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.

w/ Brake pedal Load Sensing Switch:

i.
C366045

Disconnect the brake pedal load sensing switch connector.


ii.

Disengage the clamp to separate the wire harness from the brake pedal support assembly.



b.
C366044C01
0,0 0,0 false

Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.


c.
C366046

Remove the 2 clips.


d.

Remove the 4 nuts and brake pedal support assembly.


e.
C366047

Remove the nut from the brake pedal support assembly.


Hide 47121 7.REMOVE BRAKE PEDAL PAD

a.

Remove the brake pedal pad from the brake pedal support assembly.