Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0298590 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.

·

The front speed sensor rotor is a component of the front axle hub sub-assembly. If the front speed sensor rotor is malfunctioning, replace the front axle hub sub-assembly.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 75852 2.REMOVE ROCKER PANEL MOULDING

Hide 53876A 3.SEPARATE FRONT FENDER LINER

a.
C366589

Remove the 4 screws.


b.
C366590

Remove the 3 clips and separate the front fender liner.


Hide 89543 4.REMOVE FRONT SPEED SENSOR

a.

Turn back the front fender liner.


b.
C343308

Disconnect the connector.


c.

Disengage the clamp from the vehicle body.


d.
C343309

Disengage the clamp from the vehicle body.


e.

Remove the 2 bolts and separate the 2 front speed sensor clamps.


f.
C343310

Remove the bolt and separate the front flexible hose and front speed sensor clamp from the front shock absorber assembly.


g.

Disengage the clamp from the front shock absorber assembly.


h.
C343311

Remove the bolt and front speed sensor from the steering knuckle.

NOTICE:
·

Keep the tip of the front speed sensor and installation hole free of foreign matter.

·

Do not rotate or apply excessive force to the front speed sensor when removing it from the steering knuckle. Rotating or applying excessive force may result in damage to the front speed sensor.