Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM32H0E _54 Brake _060039 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0298592 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 89245C 1.INSTALL STEERING SENSOR

a.
B279789C06
2.25,0.615 1.938,0.49 true 2.313,0.771 1.979,1.063 1.979,1.063 2.344,1.156 true 2.917,0.854 3.156,0.635 true 0.51,0.917 0.302,0.594 true 1.781,0.406 2.094,0.563 0.313,0.156 10 false *c 1.823,1 2.135,1.156 0.313,0.156 10 false *a 3.177,0.552 3.406,0.698 0.229,0.146 10 false *b 0.146,0.5 0.375,0.646 0.229,0.146 10 false *b
*a Guide
*b Pin
*c Lock Pin


Align the pins and guides, and engage the claws to install the steering sensor to the spiral cable sub-assembly.

NOTICE:
·

Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

·

Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.

·

The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.




b.
C238437

Remove the lock pin from the steering sensor.


Hide 84307 2.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY