Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor)
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0298707 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor)  IG Power Source Circuit  


DESCRIPTION

Power source voltage is supplied to the air conditioning amplifier assembly when the ignition switch is turned ON. This power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E290891E29
5.469,3.625 7.031,4.135 1.563,0.51 10 false Air Conditioning Amplifier Assembly 5.479,3.458 5.854,3.656 0.375,0.198 10 false F72 6.052,2.208 6.427,2.406 0.375,0.198 10 false GND 6.052,0.917 6.427,1.115 0.375,0.198 10 false IG+ 4.448,1.073 5.469,1.281 1.021,0.208 10 false ECU-IG1 NO. 4 5.865,0.813 6.063,1.01 0.198,0.198 10 false 5 5.823,2.073 6.094,2.302 0.271,0.229 10 false 29 0.896,0.896 2.083,1.156 1.188,0.26 10 false from Battery 0.313,1.573 1.688,2.698 1.375,1.125 10 false from Certification ECU (Smart Key ECU Assembly)*1, Ignition or Starter Switch Assembly*2 3.177,1.865 3.958,2.177 0.781,0.313 10 false IG1-NO. 1 0.385,3.625 3.448,4.083 3.063,0.458 10 false *1: w/ Entry and Start System 0.365,4.031 3.427,4.49 3.063,0.458 10 false *2: w/o Entry and Start System

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG+ POWER SOURCE)
a.

Disconnect the F72 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F72-5 (IG+) - Body ground Ignition switch off Below 1 V
F72-5 (IG+) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F72-29 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR