Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor)
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0298708 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System with Side-mounted Air Conditioner Pressure Sensor)  IG Power Source Circuit  


DESCRIPTION

Power source voltage is supplied to the air conditioning amplifier assembly when the ignition switch is turned ON. This power is used for operating the air conditioning amplifier assembly, servo motors, etc.

WIRING DIAGRAM

E290891E27
5.469,3.625 7.031,4.135 1.563,0.51 10 false Air Conditioning Amplifier Assembly 5.479,3.458 5.854,3.656 0.375,0.198 10 false F73 6.052,2.208 6.427,2.406 0.375,0.198 10 false GND 6.052,0.917 6.427,1.115 0.375,0.198 10 false IG+ 4.448,1.073 5.469,1.281 1.021,0.208 10 false ECU-IG1 NO. 4 5.865,0.813 6.063,1.01 0.198,0.198 10 false 2 5.875,2.073 6.094,2.271 0.219,0.198 10 false 4 0.927,0.865 1.844,1.208 0.917,0.344 10 false from Battery 0.208,1.333 1.729,2.125 1.521,0.792 10 false from Ignition or Starter Switch Assembly*1 or Certification ECU (Smart Key ECU Assembly)*2 3.177,1.865 3.958,2.177 0.781,0.313 10 false IG1-NO. 1 0.135,3.688 2.375,4.01 2.24,0.323 10 false *1: w/o Entry and Start System 0.146,4.156 2.385,4.479 2.24,0.323 10 false *2: w/ Entry and Start System

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - IG POWER SOURCE)
a.

Disconnect the F58 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
F73-2 (IG+) - Body ground Ignition switch off Below 1 V
F73-2 (IG+) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F73-4 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR