Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM › 2016.10–2020.08
RM32H0E _58 Vehicle Interior _059622 PRE-COLLISION _0298842 PRE-COLLISION SYSTEM C

PRE-COLLISION  PRE-COLLISION SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0125  Lost Communication with Yaw Rate Sensor Module  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U023A  Lost Communication with Front Camera Module  


DESCRIPTION

These DTCs are stored when a communication malfunction occurs between ECUs that perform pre-collision control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" When driving the vehicle at a speed of 5 km/h (4 mph) or more, a communication error between the ECM and the millimeter wave radar sensor assembly is detected for approximately 5 seconds.
·

CAN communication system

·

ECM

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0125 Lost Communication with Yaw Rate Sensor Module When driving the vehicle at a speed of 5 km/h, a communication error between the yaw rate and acceleration sensor (airbag sensor assembly) and the millimeter wave radar sensor assembly is detected for approximately 1 second.
·

CAN communication system

·

Yaw rate and acceleration sensor (Airbag sensor assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0126 Lost Communication with Steering Angle Sensor Module When the ignition switch to ON, a communication error between the steering angle sensor (spiral cable with sensor sub-assembly) and the millimeter wave radar sensor assembly is detected for approximately 4 seconds.
·

CAN communication system

·

Steering angle sensor (Spiral cable with sensor sub-assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U0129 Lost Communication with Brake System Control Module When the ignition switch to ON, a communication error between the skid control ECU (brake actuator assembly) and the millimeter wave radar sensor assembly is detected for approximately 3 seconds.
·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

Millimeter wave radar sensor assembly

·

Wire harness or connector


U023A Lost Communication with Front Camera Module After the ignition switch is turned to ON, a communication malfunction occurs between the millimeter wave radar sensor assembly and forward recognition camera.
·

CAN communication system

·

Forward recognition camera

·

Millimeter wave radar sensor assembly

·

Wire harness or connector



PROCEDURE

1.CHECK FOR DTCs (PRE-COLLISION SYSTEM)
a.

Clear the DTCs.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Collision 2 > Clear DTCs
50002 220

b.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



c.

Check for DTCs.

Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>DTC CHECK / CLEAR

Body Electrical > Pre-Collision 2 > Trouble Codes
50001 220

Result:
Result Proceed to
DTC U0100, U0125, U126 and U0129 are not output A
DTC U0100, U0125, U126 or U0129 is output B



A

B