DTC B2793 is stored when a malfunction is found in the key during key ID code registration or a key ID code is not registered normally. Replace the key if key ID code registration cannot be performed normally and this DTC is output.
DTC B2794 is stored when a key with an incomplete key ID code is inserted into the ignition key cylinder.
DTC B2797 is stored when a key with a BCC malfunction is inserted into the ignition key cylinder.
DTC B2798 is stored when a key is inserted into the ignition key cylinder but a communication error occurs between the key and transponder key ECU assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2793 | Transponder Chip Malfunction | A transponder chip malfunction (1 trip detection logic*). | ·
Key ·
Transponder key coil ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
| B2794 | Unmatched Encryption Code | A key with an incomplete key ID code is inserted into the ignition key cylinder (1 trip detection logic*). | ·
Key ·
Transponder key coil ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
| B2797 | Communication Malfunction No. 1 | A key with a BCC malfunction is inserted into the ignition key cylinder (1 trip detection logic*). | ·
Key ·
Transponder key coil ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
| B2798 | Communication Malfunction No. 2 | Key ID code identification cannot be completed within the specified time (1 trip detection logic*). | ·
Key ·
Transponder key coil ·
Transponder key ECU assembly |
DTC Output Confirmation Operation:
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC No. | Data List and Active Test |
|---|---|
| B2793 | - |
| B2794 | - |
| B2797 | - |
| B2798 | - |
If the transponder key ECU assembly or key is replaced, refer to Service Bulletin.
After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Insert and remove each registered key one at a time, and check for DTCs each time.
Before checking for DTCs, perform "DTC Output Confirmation Operation" procedure.
If DTC B2793, B2794, B2797, or B2798 are stored, clear the DTCs before checking the next key.
DTC B2793, B2974, B2797 and B2798 is not output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output for all of the keys | B |
| DTCs are output for any of the keys | C |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
Check that the connectors are properly connected to the transponder key coil.
Check that the engine starts with the key.
Engine starts.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the transponder key coil.
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TRANSPONDER KEY AMPLIFIER>REMOVAL
Check that the engine starts with the key.
Engine starts.
| Proceed to |
|---|
| OK |
| NG |
OK
NG