Home › Drivetrain › CLUTCH › CLUTCH PEDAL (for RHD)
RM32H0E _52 Drivetrain _059611 CLUTCH _0292332 CLUTCH PEDAL(for RHD) G

CLUTCH  CLUTCH PEDAL(for RHD)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT AND ADJUST CLUTCH PEDAL HEIGHT

a.

Turn back the floor carpet.


b.

Check that the clutch pedal height is correct.

C366504C01
2.01,2.167 2.323,2.365 0.313,0.198 10 true *a 6.333,2.875 6.646,3.073 0.313,0.198 10 true *a
*a Clutch Pedal Height from Clip - -


Clutch pedal height from clip:

177.8 to 191.8 mm (7.00 to 7.55 in.)



Hide 2.INSPECT AND ADJUST PEDAL FREE PLAY AND PUSH ROD PLAY

a.
C368399C01
2.583,2.99 2.896,3.188 0.313,0.198 10 false *a
*a Clutch Pedal Free Play


Check that the clutch pedal free play are correct.

HINT:

Pay close attention to the change in resistance to distinguish clutch pedal free play while performing the inspection.


i.

Depress the clutch pedal until clutch resistance begins to be felt.

Clutch pedal free play:

4.2 to 10.6 mm (0.165 to 0.417 in.)




Hide 3.INSPECT CLUTCH RELEASE POINT

a.
C227877C10
1.365,1.177 1.615,1.177 false 1.615,1.583 2.281,1.042 2.281,1.042 2.396,1.042 true 1.354,1.521 0.906,1.885 0.906,1.885 0.802,1.885 true 1.396,0.99 1.635,1.198 0.24,0.208 10 false *c 1.802,1.917 2.063,2.125 0.26,0.208 10 false *d 0.646,1.802 0.948,2.052 0.302,0.25 10 false *b 2.458,0.969 2.719,1.198 0.26,0.229 10 false *a
*a Release Point
*b Full Stroke End Position
*c from Clutch Pedal Stroke End Position to Release Point
*d Clutch Pedal Stroke


Check the release point.

i.

Apply the parking brake and install wheel chocks.


ii.

Start the engine and run it at idle.


iii.

Without depressing the clutch pedal, slowly move the shift lever into reverse until the gears contact each other.


iv.

Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.

Standard distance:

25 mm (0.984 in.) or more (from Clutch Pedal stroke end position to release point)


Clutch pedal stroke (Reference):

132.4 to 142.4 mm (5.21 to 5.61 in.)


If the distance is not as specified, perform the following procedure:

·

Check the clutch pedal height.

·

Check the push rod play and clutch pedal free play.

·

Bleed the clutch line.

·

Check the clutch cover and the clutch disc.




b.

Install the floor carpet.