Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM › 2016.10–2019.09
RM32H0E _58 Vehicle Interior _059623 SEAT _0299515 FRONT POWER SEAT CONTROL SYSTEM D

SEAT  FRONT POWER SEAT CONTROL SYSTEM  OPERATION CHECK  


CHECK POWER SEAT FUNCTION


a.
A395222C01
1.021,1.542 1.198,1.542 1.198,1.542 1.51,2.031 false 0.813,1.406 1.125,1.563 0.313,0.156 10 false *a
*a Lumbar Support Adjustment Function


Check the basic functions.

i.

Operate the front lumber power seat switch and check the lumbar support adjustment function operates properly:




CHECK LUMBAR SUPPORT ADJUSTMENT MOTOR


a.

Check the PTC operation inside the lumbar support adjustment motor.

NOTICE:

The inspection should be performed with the seat installed to the vehicle.


i.

Operate the front lumbar power seat switch and move the lumbar support to either the foremost or rearmost position. Keep the seat in that position for approximately 60 seconds.


ii.

Operate the front lumbar power seat switch again and continue to try to move the lumbar support in the same direction as in the previous step. Measure the time until the current is shut off (motor operation sound stops).

Standard:

4 to 90 seconds



iii.

After the current is shut off, release the front lumbar power seat switch and wait for approximately 60 seconds.


iv.

Operate the front lumbar power seat switch and move the lumbar support in the opposite direction. Check that the motor operates.