Home › Vehicle Interior › HEATING / AIR CONDITIONING › BLOWER UNIT (for DENSO Made)
RM32H0E _58 Vehicle Interior _059841 HEATING / AIR CONDITIONING _0299518 BLOWER UNIT(for DENSO Made) A

HEATING / AIR CONDITIONING  BLOWER UNIT(for DENSO Made)  DISASSEMBLY  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

Make sure to perform initialization after replacing the No. 1 blower damper servo sub-assembly. If initialization is not performed, the air conditioner unit assembly will not perform properly as the air conditioning amplifier assembly will not be able to recognize the position of the No. 1 blower damper servo sub-assembly.


Hide 88899M 2.REMOVE AIR FILTER COVER PLATE

a.
E338252C02
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Disengage the claw and guides as indicated by the arrows, in the order shown in the illustration to remove the air filter cover plate.


Hide 87139C 3.REMOVE CLEAN AIR FILTER

a.
E338254C02
0,0 0,0 false
V113147

Remove in this Direction


Remove the air filter sub-assembly as shown in the illustration.


b.
E331020

Disengage the guides to remove the clean air filter from the cooling unit parts.


Hide 87103B 4.REMOVE BLOWER MOTOR WITH FAN SUB-ASSEMBLY

a.
E338266

Remove the 3 screws and blower motor with fan sub-assembly.


Hide 87130K 5.REMOVE NO. 1 BLOWER DAMPER SERVO SUB-ASSEMBLY

a.
E337809

Remove the 2 screws and No. 1 blower damper servo sub-assembly.