Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › 2016.10–2020.08
RM32H0E _58 Vehicle Interior _060065 SEAT BELT _0299547 SEAT BELT WARNING SYSTEM W

SEAT BELT  SEAT BELT WARNING SYSTEM  CUSTOMIZE PARAMETERS  


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.

·

These buzzers should be ON for safe driving. Perform this procedure only if it is necessary to set the buzzer to OFF (disabled).



Customizing with the GTS


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Customize Setting / Warning.


e.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
Driver Side Seatbelt Warning Buzzer Function to sound the driver seat belt warning buzzer ON 0:OFF,1:ON Combination meter assembly
Front Passenger Side Seatbelt Warning Buzzer Function to sound the front passenger seat belt warning buzzer ON 0:OFF,1:ON Combination meter assembly
Rear Seatbelt Warning Buzzer Function to sound the rear seat belt warning buzzer* ON 0:OFF,1:ON Combination meter assembly
50006 7

*: w/ Rear Seat Belt Warning

HINT:

This setting is only valid when the vehicle is driven at 20 km/h (12 mph) or more.