Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM › 2016.10–2020.08
RM32H0E _58 Vehicle Interior _060065 SEAT BELT _0299547 SEAT BELT WARNING SYSTEM U

SEAT BELT  SEAT BELT WARNING SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter or Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
P-Seatbelt Buckle SW Front passenger seat belt buckle switch signal ON or OFF ON: Front passenger seat belt not fastened
OFF: Front passenger seat belt fastened
Perform the inspection while sitting in the front passenger side seat.
2nd-Row Seatbelt Buckle (R) Rear RH seat belt buckle switch signal ON or OFF ON: Rear RH seat belt not fastened
OFF: Rear RH seat belt fastened
w/ Rear Seat Belt Warning
2nd-Row Seatbelt Buckle (L) Rear LH seat belt buckle switch signal ON or OFF ON: Rear LH seat belt not fastened
OFF: Rear LH seat belt fastened
w/ Rear Seat Belt Warning
2nd-Row Seatbelt Buckle (C) Rear center seat belt buckle switch signal ON or OFF ON: Rear center seat belt not fastened
OFF: Rear center seat belt fastened
w/ Rear Seat Belt Warning
Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer ON or OFF Customized value displayed -
P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer ON or OFF Customized value displayed -
Rear Seatbelt Warning Buzzer Rear seat belt warning buzzer ON or OFF Customized value displayed w/ Rear Seat Belt Warning
Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Door Courtesy SW Rear door courtesy light switch RH ON or OFF ON: Rear door RH open
OFF: Rear door RH closed
-
RL Door Courtesy SW Rear door courtesy light switch LH ON or OFF ON: Rear door LH open
OFF: Rear door LH closed
-
D Seat Buckle SW Driver seat belt buckle switch ON or OFF ON: Driver seat belt unfastened
OFF: Driver seat belt fastened
-


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Driver Side Seat Belt Seat belt warning light OFF/ON -