Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2016.10–2019.09
RM32H0E _56 Audio / Visual / Telematics _060815 NAVIGATION / MULTI INFO DISPLAY _0299845 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Microphone Circuit between Radio Receiver and Extension Module  


DESCRIPTION

This circuit sends a microphone voice signal from the navigation ECU to the radio and display receiver assembly.

Using this circuit, the navigation ECU disables the microphone function of the radio and display receiver assembly to receive a microphone voice signal from the telephone microphone assembly.

WIRING DIAGRAM

E360817E01
0.635,1.865 1.094,2.063 0.458,0.198 10 false F80 0.635,2.052 2.333,2.531 1.698,0.479 10 false Radio and Display Receiver Assembly 5.448,1.875 5.906,2.073 0.458,0.198 10 false F83 5.448,2.052 6.604,2.458 1.156,0.406 10 false Navigation ECU 5.635,0.542 6.094,0.74 0.458,0.198 10 false MIC+ 5.635,0.979 6.094,1.177 0.458,0.198 10 false MIC- 1.125,1.406 1.583,1.604 0.458,0.198 10 false SGND 1.115,0.542 1.573,0.74 0.458,0.198 10 false MCO+ 1.125,0.969 1.583,1.167 0.458,0.198 10 false MCO- 1.625,0.417 1.781,0.615 0.156,0.198 10 false 5 1.615,0.865 1.771,1.063 0.156,0.198 10 false 6 1.615,1.302 1.771,1.5 0.156,0.198 10 false 1 5.354,0.458 5.573,0.646 0.219,0.188 10 false 16 5.354,0.875 5.573,1.063 0.219,0.188 10 false 17 3.271,1.24 4.083,1.5 0.813,0.26 10 false (Shielded)

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the F80 radio and display receiver assembly connector.


b.

Disconnect the F83 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F80-5 (MCO+) - F83-16 (MIC+) Always Below 1 Ω
F80-6 (MCO-) - F83-17 (MIC-) Always Below 1 Ω
F80-5 (MCO+) or F83-16 (MIC+) - Body ground Always 10 kΩ or higher
F80-6 (MCO-) or F83-17 (MIC-) - Body ground Always 10 kΩ or higher
F80-1 (SGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR