75861C
1.INSTALL ROCKER PANEL MOULDING PAD
Using the same procedure, remove every rocker panel moulding pad.
When installing the rocker panel moulding pad, heat the rocker panel moulding using a heat light.
| Item | Temperature |
|---|---|
| Rocker Panel Moulding | 20 to 30°C (68 to 86) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rocker panel moulding excessively.
Clean the rocker panel moulding surface.
Using a heat light, heat the rocker panel moulding surface.
Remove the double-sided tape from the rocker panel moulding.
Wipe off any tape adhesive residue with cleaner.
Using a heat light, heat the rocker panel moulding.
Remove the release paper from a new rocker panel moulding pad.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Line |
Install the rocker panel moulding pads.
Install a rocker panel moulding pad along the line on the rocker panel moulding.