Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
61992
1.INSTALL FRONT PILLAR COVER PROTECTOR
When installing the front pillar cover protector, heat the front pillar upper cover sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Front Pillar Upper Cover Sub-assembly | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front pillar upper cover sub-assembly excessively.
Clean the front pillar upper cover sub-assembly surface.
Using a heat light, heat the front pillar upper cover sub-assembly surface.
Remove the double-sided tape from the front pillar upper cover sub-assembly.
Wipe off any tape adhesive residue with cleaner.
Using a heat light, heat the front pillar upper cover sub-assembly.
Remove the release paper from a new front pillar cover protector.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *1 | Mark-off Line |
| *a | 3.0 mm (0.118 in.) |
Install the front pillar cover protector as shown in the illustration.
Align the front pillar cover protector with the mark-off line of the front pillar upper cover sub-assembly.