These DTCs are stored when the CAN communication system is malfunctioning.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| U0073 | Control Module Communication Bus OFF | Lost communication with CAN communication line | CAN communication system | - |
| U0100 | Lost Communication with ECM / PCM "A" | Lost communication with ECM | ·
CAN communication system ·
ECM |
- |
| U0129 | Lost Communication with Brake System Control Module | Lost communication with brake actuator assembly (skid control ECU) | ·
CAN communication system ·
Brake actuator assembly (skid control ECU) |
- |
| U0142 | Lost Communication with Body Control Module "B" | Lost communication with main body ECU (multiplex network body ECU) | ·
CAN communication system ·
Main body ECU (multiplex network body ECU) |
- |
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch to ON.
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>DTC CHECK / CLEAR
DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING